A piece of White Ash from our bush lot, the first tool paths flattened the top then the engraving of the text and clock numbers.

Painting the engraved areas with a tiny brush and laytex paint.

The top is planed again with a pocketing raster toolpath in the direction of the wood grain.

Last steps to finish with a clear satin laquer and install the clock movement.

This is a horizontal style some with the Logo on the right or left, and there are vertical with the Logo on the top or bottom. Pine.

Very poor photo, this is from Pine and stained too dark, not good.

Pine.

And one from MDF that could be painted, if you like.

Another from MDF.

Clock I made for the Wood Working and Craft Centre.

White Ash rough live edge.

Many like the live edge.

After engraving the text and the 3D image, I painted the text.

Next step is to remove the paint around the text.

A closer look. The wood is Black Cherry cut from our wood lot, cut to lumber then air dried outside for 3 years.

Clock movement installed and stain applied. Sonny is a car collector.